Twice today, after and during really severe rainstorms, my Maytag MAV2620AWW machine has started filling with cold-water and overflowing the drum. The machine is down, not established between rounds and unplugging it's no impact. I startsd the spin period to clear the machine, which worked, then your washer extended to load with water. The only real treatment was to slice the water using the exterior tap. Starting the device immediately triggered the machine to carry on to load. I went and did some chores and attempted again 5 hours later. After I switched the device I noticed a gush of water and also the circulation started again. Five moments later there is a press and also the water ceased. The machine today worked as normal. I'd somebody come an consider the device and he explained that reduced street side stress might lead to the solinoid to drop-out and permit the infinite circulation of water. Whilst the solinoid is electric and never pressure-activated I can not observe how that is appropriate. Should not I be changing the water solinoid stop? Any suggestions could be appriciated!
0 comments