Your A/D worked perfectly till following its yearly appointment by Motion on June 5.
On that evening, the specialist attempted to market us a brand new device. He explained that the contact was burned (we examined it and noticed that it revealed indications to be burned), and since the device was obsolete, it takes Freon, support might quickly not be available since Freon wouldn't be accessible.
We asked when the Freon stress was presently ok, and he explained it had been. Each dayapproximately after his visit, nevertheless, the A/D ceased cooling the home. It went permanently, but there is no great atmosphere, and also the evening next, we discovered it frozen over. While Motion returned to consider the issue, the "new" specialists informed us the Freon stress was reduced due to a trickle within the heat exchanger! They discovered the stress to become at 60 PSI; regular is 75 PSI
Your feeling is the fact that the very first technology triggered the Freon strain, because which was his primary stage in attempting to sell us a brand new device. We think he lied when he explained the Freon was good since he understood when he explained there is an issue, we'd wish to view it ourselves, once we did using the contact.By laying about this, we'd no cause to check on it out, and therefore, the sabatage wouldn't be found till it was too late.
We went, in a of times, from the completely well-working A/D unit to some low-working A/H device. The point that occurred between these 2 times was a trip from Motionis specialist! We think the technology triggered the trickle that cleared the Freon. He did not record any Freon issues when he examined the system, and that is since, we think, there is no Freon issue till AFTER he caused it.
0 comments