Y 51 looks of all of the rounds. Just the 'whitest whites' period appears to be untouched. The equipment stops entirely. Easily drive the end switch, the error message disappears. Easily struck the start switch the equipment will begin again but instantly dates back into trouble. I subsequently need to stop the cycle, allow it to strain, and begin the 'wash, spin, drain cycle', however now this cycle gets the error signal. Therefore essentially I can not operate an entire wash period, I can not wash and spin the soap from the garments, therefore the weight is left notably clear, notably rinsed, and sopping wet. Our machine was bought September 28. The problem began soon after the main one year warranty expired. I investigated the problem signal online and also have decided the motherboard must be changed. This can charge between $200-400, to get a device that's experienced use for under 2 yrs. This week we obtained an application notice from Sears informing us when the sequential number on our machine dropped inside a particular variety, mom board could be improved free of charge to us. Your device includes a sequential number that's higher (CU rather than the CS-CT variety) which suggests in my experience that it had been produced following the target devices. Which means that Sears is aware of the issues but up to now is reluctant to repair our device free of charge to us. They've the sequential amount of our device on document. Why did they deliver the notice to us comprehending that our device has gone out of the goal array? Do I've to pay for to obtain my device mounted while older devices obtain a free update? We are calling Sears to determine if they're prepared to correct the problem. The machine was highly-rated on Consumer Reviews buts it seems the design is just a orange.
0 comments