Oximeter
Oximete

2.1 Common accident prevention V-belt fire prevention 1) the use of flame-retardant tape, even if the fire, but also to control the fire Buzhi Yu rapidly. 2) to enhance the maintenance of elevator belting electrical equipment to prevent fires caused by electrical accidents. 3) strengthen management, to keep roadways clean and free floating on the tape of coal, water, no oil, no debris, nose, tail no heap of coal. Improve the quality of operation and maintenance personnel to maintain the good running conveyor. 4) The poly v-belts installation of conveying confidential inspection and monitoring devices, such as the drive roller and driven roller temperature monitoring devices, smoke alarms Conveyor belt fasteners and automatic event of fire sprinklers. 2.2 Prevention of Accidents deviation 1) to purchase qualified products recognized by the state to avoid the lack of precision equipment manufacturing Other Rubber Products deviation caused by the accident. 2) install the installation process to focus on dimensional accuracy of: a.installation tape found at the deviation in the drum, the drum level degree should be corrected and equal degree, drive pulley, steering roller center line of flat transmission belts the width of the installation Rough top Conveyor belt requirements of the center line coincides with the tape of not more than 2mm, the midline axis of the vertical line and the tape is no more than a fraction of the width of the roller, roller shaft level of not more than 0.3/1000. B. If you find that tape in the no-load to the side where the total should be adjusted roller bracket. C. Rosetta Stone If you find that tape in the no-load without deviation, rubber sheet and deviation to the side of heavy load, partial load that tape there should adjust the position of vent coal bucket. 3) to strengthen routine maintenance: a. Timely removal of conveyor rollers, roller, V-belt

V-belts

Rubber V-belts

Wrapped V-belt

Raw edge cogged V-belt

Variable Speed V-belt

Flat transmission belt then expected at the other major parts of the Automotive V-Belt coal dust, and prevent roller, roller-stained dust lead tape deviation. B. To adjust belt deviation occurred in the operation of the phenomenon, check the tape edges and joints in time wear, identify problems and timely replacement and repair. 4) The deviation of the monitoring devices installed Special belts tape, once deviation tape to send alarm signals to alert maintenance personnel to take action. 2.3 Prevention of Accidents tear 1) timely repair worn Automotive V-Belts funnel, waste rock and coal to avoid direct pound

Company: Oximeter
Country: USA
State: Iowa
Site: door2doorshop.com

  <     >