USB ID-modeswitch ZTE
ZTE631 Modem, ZTE WCDMA Technologies Unable to run the usb_id modeswitch on this ARM based embedded device

Problem in switching ZTE631. I need to run usbid_modeswitch on an ARM based embedded device.
Where I installed usbid-modeswitch-1.1.9-jimsh. Tar. Bz2 along with the usbid-modeswitch-data package.

Now when, I put my dongle (ZTE631 Modem), it fails to switch. I can't get help from phone in customer support so I'm posting this online for help. Changing the ID on my USB port is not working.

I have enabled log, which looks like:
Code:
USBID_ModeSwitch log from Thu Aug 18 12:26: 18 UTC 2011

Raw args from udev: 1-1:1.0/1-1:1.0 {}

Using global config file: / etc/usbid_modeswitch. Conf

USBID values from sysfs:
manufacturer ZTE, Incorporated
product ZTE WCDMA Technologies MSM
serial MF6310ZTED010000

BNumConfigurations is 1 - don't check for active configuration
SCSI attributes not needed, moving on
checking config: / usr/share/usbid_modeswitch/19d2:2000
! Matched, now switching
(running command: / usr/sbin/usb_modeswitch -I -W -c / usr/share/usb_modeswitch/19d2:2000)

Verbose debug output of usb_modeswitch and libusb follows
(Note that some USB errors are expected in the process)

Reading config file: / usr/share/usb_modeswitch/19d2:2000

* usbid_modeswitch: handle USB devices with multiple modes
* Version 1.

Company: USB ID-modeswitch ZTE
Country: USA
Address: 3630 Peachtree Rd NE, Atlanta GA
Site: zteusa.com

  <     >